New Free Surface/Storm Water Design Service

In response to customer requests BMS are happy to announce a big investment in our surface and storm water drainage design capability.

New Design Engineer

BMS have appointed, Philip Sheridan, as a full time Design Engineer.  Philip has 10 + years’ experience in design and drawing preparation and will be focusing on surface water design, drawing preparation and product design.  Philip is a very welcome addition to BMS and greatly adds to our design capability across our product range.

Philip Sheridan: BMS Surface Water & Product Design EngineerPhilip Sheridan: BMS Surface Water & Product Design Engineer

Surface & Stormwater Management Design Software

BMS have also invested in state of the art drainage/SuDS design software which allows us to fully design surface and storm water management systems for our clients from the ground up, which complies with Sustainable urban Drainage Systems (SuDS) regulations.

Why surface and stormwater design is required on new sites.

John Lee, BMS Surface Water specialist, commented that all new developments must take into account any additional surface water flows generated by the development and install measures to mitigate these storm flows e.g. attenuation/infiltration systems, along with water protection systems such petrol/oil interceptors/separators, silt traps and vortex oil/silt separators.

The general principle of surface water management is that the storm water runoff post development is equal or better than that pre-development.  Calculating this storm water runoff and devising appropriate ways to manage it can be complex and require specialist knowledge.  Therefore, in response to customer requests BMS have invested in the area in the form of our new design Engineer and specialist surface and storm water management software.  This a free service available to Consulting Engineers and other designers in the area.

BMS One Stop Shop for surface and storm water management

BMS are a 32 year old manufacturer of products for surface water and wastewater treatment.  The majority of BMS products are manufactured in its ISO 9001 Quality factory in Longford, Ireland.  BMS are uniquely able to offer a ‘one stop shop’ for all surface water products from design to installation including attenuation, interceptors, holding tanks (incl. chemical resistant), hydrobrakes, rainwater harvesting tanks/filters & vortex silt separators, chlorine contact tanks, fully fitted pumps and sumps and much more.

How to contact BMS

If we can help you designing a surface or storm water drainage system or you need advice please contact us.  We enjoy talking to you.

Phone: +353 43 3326100

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.